Introduction; Important Safety Instructions; Safety Requirements - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual
1. I
NTRODUCTION

1.1 Important Safety Instructions

1.1.1 Safety Requirements


When using your telephone equipment, basic safety precautions should always be
followed to reduce the risk of fire, electric shock and other personal injury, including the
following:

Please read and understand all instructions.

Follow all warnings and instructions marked on the product.

Unplug this product from the wall outlet before cleaning. A slightly damp cloth should be
used for cleaning; do not use liquid or aerosol cleaners.

Do not use this product near water, such as bathtub, washbowl, kitchen sink or laundry tub,
a wet basement, or near a swimming pool.

Do not place this product on an unstable stand or table. The product may fall, causing
serious damage to the product or serious injury.

Slots and openings in the KSU and the back or bottom are provided for ventilation, to
protect it from overheating, these openings must not be blocked or covered. The openings
should never be blocked by placing the product on a bed, sofa, or other similar surface.
This product should never be placed near or over a radiator or other heat source. This
product should not be placed in a built-in installation without proper ventilation.

This product should be operated only from the type of power source indicated on the
product label. If you are not sure of the type of power supply to your location, consult your
dealer or local power company.

Do not allow anything to rest on the power cord. Do not locate this product where the cord
could be abused by people walking on it.

Do not overload wall outlets and extension cords as this can result in the risk of fire or
electric shock.

Never push objects of any kind into this product through KSU slots or connectors as they
may touch dangerous voltage points or short out parts that could result in a risk of fire,
electric shock or product failure. Never spill liquid of any kind on the product.

To reduce the risk of electric shock, do not disassemble this product. Instead, take it to a
qualified person when service or repair work is required. Opening or removing covers may
expose you to dangerous voltages or other risk. Incorrect reassemble can cause electric
shock when the appliance is subsequently used.

Unplug this product from the wall outlet and refer servicing to qualified service personnel
under the following conditions:
1. When the power supply cord or plug is damaged or frayed.
2. If liquid has been spilled into the product.
3. If the product has been exposed to rain or water.
4. If the product does not operate normally by following the operating instructions. Adjust
only those controls that are covered by the operating instructions because improper
adjustment of other controls may result in damage and will often require extensive work
by a qualified technician to restore the product to normal operation.
1
Issue 1.0