iPECS eMG80 Installation Manual page 92

iPECS eMG80
Hardware Description and Installation Manual
4. If not using a POE switch port, connect the DC connector of an AC Adaptor-K to the
DC input on the bottom of the IP Phone and plug the AC plug of the AC adaptor in to
a 100-240 VAC outlet.
Once the LIP phone powers up, it will attempt to register with the eMG80. From default, the
LIP phone should complete the registration successfully. If not, the phone will display the
"No Response" message shown below.
NO RESPONSE FROM MFIM [L]
SET[*] – RETRY[#]
This indicates the LIP phone needs to be configured for the local network environment. To
configure the phone, perform the following steps.
1. Press '*' to set the network configuration
2. Enter the password, 147*.
3. Use the Volume Up/Down buttons to scroll through the menu shown below.
4. Enter appropriate values for the local network.
5. When complete, press the Speaker button.
6. Press '*' to exit and restart the LIP Phone.
MODE[R/L]
[LOCAL] – CHANGE[#]
PHONE IP ADDRESS (DOT:*)
PHONE NET MASK(DOT:*)
ROUTER IP ADDRESS(DOT:*)
MFIM IP ADDRESS(DOT:*)
SAME LAN WITH MFIM
[YES] – CHANGE[#]
INPUT DEVICE NUMBER:
DHCP ?
[DISABLED] – CHANGE[#]
VLAN CONFIGURATION
NOT SET
WEB PASSWORD
PHY MODE : AUTO NEGO
CHANGE[*] SAVE[#]
Menu Display Description
Registration mode, use '#' to set Remote mode
Use the dial pad to enter the fixed IP address,
use DHCP for dynamic addressing
Use the dial pad to enter the Subnet mask if
using fixed IP addressing
Use the dial pad to enter the default Gateway if
using fixed IP addressing
Use the dial pad to enter the IP address of the
MFIM IP address.
Indicates if the IP Phone and the eMG80 are on
the same LAN segment. Use # to change,
Yes/No.
The IP Phone supports fixed or dynamic
addressing, use # to change the value.
Not used
Not used
Speed and Duplex negotiation, use * to change
the selection
85
Issue 1.0