Slb16 (Slt 16 Interface Board) - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual

4.7.9 SLB16 (SLT 16 Interface Board)

Description
The SLB16 board is shown in
eight of the 16 SLT interface ports are provided from the SLU8 daughter that is factory
installed. The board can be installed on CN1 connector of the KSU or EKSU for expansion.
The board is provided with two Standoffs that must be installed prior to mounting the board.
To install the board in the KSU, refer to Section 4.4. Note the SLB16 does not include a
pass-through connector and thus should be installed as the top Interface board.
Connector and Modular jack
Table 4.7.9-1 Connector and Modular Jack Function
Connector
CN2
CN3
MJ2
LED Indications
LD1
Figure 4.7.9-1 and has 16 SLT interface circuits. Note that
Figure 4.7.9-1 SLB16
Connection to CN1 of Interface board
CPLD JTAG for development
16 SLT line
Table 4.7.9-2 SLB16 LED Indications
LED Color
Blue Station port in use status
ON: a station port is in use
OFF: All station ports are idle
Functions
Description
52
Issue 1.0
Remark
70 pins
10 pins
RJ11