Terminal Wall Mount; Ldp-7000 And Ldp-9000 Series Wall Mount - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual

7.4 Terminal Wall Mount

7.4.1 LDP-7000 and LDP-9000 series Wall Mount

The LDP-7000 and LDP-9000 series phones can be mounted on the wall using the
appropriate Wall Mount Kit. The Wall Mount Kit is installed as described below. A separate
Wall Mount kit, available from Ericsson-LG, is required for the LDP-7000 series phones.
1. Using the appropriate Wall Bracket, mark and drill two (2) 7 mm holes for the plastic
wall anchors provided.
2. Insert the two (2) anchors into the holes and insert and tighten the 2 screws leaving
about 6 mm (¼-inch) exposed.
3. Connect one end of a short cable terminated in RJ11 to the LDP-7000 series Phone,
respectively, and then connect the other end in a wall jack.
4. Mount the Wall Mount bracket on the phone.
5. Slide the Wall Mount bracket over the screws, if loose, tighten the screws slightly
and mount the Wall Mount bracket again.
6. Insert the Wall Mount handset hook to prevent the handset from slipping when wall
mounted.
Figure 7.3.4-3 LIP-8000 DSS Installation
88
Issue 1.0