Precaution - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual
5. If the product has been dropped or the KSU has been damaged.
6. If the product exhibits a distinct change in performance.

Avoid using a telephone during an electrical storm. There is a remote risk of electric shock
from lightning.

In the event of a gas leak, do not use the telephone near the leak.

1.1.2 Precaution


Keep the system away from heating appliances and electrical noise generating devices
such as florescent lamps, motors and televisions. These noise sources can interfere with
the performance of the iPECS eMG80 System.

This system should be kept free of dust, moisture, high temperature (more than 40
degrees) and vibration, and should not be exposed to direct sunlight.

Never attempt to insert wires, pins, etc. into the system. If the system does not operate
properly, the equipment should be repaired by an authorized Ericsson-LG service center.

Do not use benzene, paint thinner, or an abrasive powder to clean the KSU. Wipe it with a
soft cloth only.

This system should only be installed and serviced by qualified service personnel.

When a failure occurs which exposes any internal parts, disconnect the power supply cord
immediately and return this system to your dealer.

To prevent the risk of fire, electric shock or failure of the system, do not expose this
product to rain or any type of moisture.

To protect the internal components from static electricity, discharge body static before
touching connectors and/or components by touching ground or wearing a ground strap.

To reduce the risk of fire, use only No. 26 AWG or larger (e.g., 24 AWG) UL Listed or CSA
Certified Telecommunication Line Cord.

The Power supply cord is used as the main disconnect device. Ensure that the socket-
outlet is located, installed near the equipment and is easily accessible.

A supplementary equipment earthing conductor is to be installed between the product or
system and earth, that is, in addition to the equipment earthing conductor in the power
supply cord.

Disconnect the Telecom connection before disconnecting the power connection prior to
relocating the equipment, and reconnect the power first.

This system is equipped with an earthing contact plug. For safety reasons this plug must
only be connected to an earthing contact socket which has been installed according to
regulations.
WARNING
Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries
According to the Instructions.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions and local disposal
requirements.
2
Issue 1.0