Terminal Connection; Dktu Wiring - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual

7.3 Terminal Connection

7.3.1 DKTU Wiring

The Digital Key Telephone and digital DSS Console are terminated to a pair of the RJ11
located in the bottom of the unit. The LDP-72xx series phones employ the 2
modular jack while all other LDP series phones employ the 1
jack. The wall outlet for the DKT or Console should be wired to the appropriate termination
point for the DKT port in the eMG80 system.
1. Using the Modular Jack wiring charts below, wire the 1
as appropriate, to the termination point using UTP cable. Note separate wiring is
required for the LDP-7048 DSS Console.
2. Using the line cord provided, connect the DKTU or DSS Console to the wall outlet.
Modular Jack Pin Assignment
Connector
RJ11
Table 7.3.1-2 LDP-7000 and 9000 series Modular Jack Wiring
Connector
RJ11
Table 7.3.1-1 LDP-7200 series Modular Jack Wiring
Pin-out
Pin-out
st
or center pair of the modular
st
Pin Number Signal Name
1 N/A
2 RING
3,4 Reserved
5 TIP
6 N/A
Pin Number Signal Name
1 N/A
2 Reserved
3,4 RING, TIP
5 Reserved
6 N/A
83
Issue 1.0
nd
pair of the
nd
or 2 pair of the wall outlet,