Replace The Cord Cover - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual

6.9.3 Replace the Cord Cover

Once the wiring is complete and dressed, the Cord cover should be replaced to minimize
accidental damage and the potential of tampering with the wiring. To attach the cover, refer
to Figure 6.9.3-1 and perform the following step,
1. Position the cover on the side of KSU, locating the cover tabs with the matching
slots in the KSU.
2. Place the tabs in the slots and rotate the cover toward the KSU in the direction of
arrows as shown in figure #1.
3. Press down on the cover near the screw hole as shown in figure #2 to expose the
screw hole.
4. Affix the cover with screw provided as shown in figure #3.
Figure 6.9.3-1 Replacing the Cord cover
80
Issue 1.0