Installing Dimms; Table 4-1 Workstation Internal Layout - Sun Microsystems Sun Blade 150 Getting Started Manual

TABLE 4-1
Item in

Installing DIMMs

When installing additional DIMMs, first fill the connector closest to the motherboard
edge, then fill toward the CPU, as shown in
Note – To maximize performance, the DIMMs in this workstation have been
specifically designed for it. Do not use DIMMs from a different system to upgrade or
replace the DIMMs in this workstation. Verify with your Sun sales or service
representative that the DIMMs you are installing have been Sun-certified for the Sun
Blade 150.
44 Sun Blade 150 Getting Started Guide • June 2002
Workstation Internal Layout
FIGURE 4-5
Part Description
Four dual inline memory modules (DIMM) connectors on the
1
motherboard (
PCI card connectors on the riser board.
2
PCI card connector 3 is visible. PCI card connector 1 and PCI
card connector 2 are not visible in
Power supply
3
Hard drive and tray for hard drive (not shown). The tray can
4
house two hard drives (
CD-ROM or DVD-ROM drive
5
PCI card guide
6
PCI or graphics accelerator board
7
Peripheral assembly, which contains a smart card reader and
8
can contain an optional diskette drive.
)
FIGURE 4-5
FIGURE 4-5
c).
FIGURE 4-11
.
FIGURE 4-6
.