Sun Microsystems Sun Blade 150 Getting Started Manual page 67

4. Pull the hard drive tray out of the chassis and set it on an antistatic mat
(
FIGURE 4-11 C).
5. Place the secondary hard drive onto the hard drive tray, then hold the drive in
place while you turn the tray upside-down on the antistatic mat (
Note – Before you replace any hard drive, verify that the hard drive mode-select
jumper is correctly set to "CS", "Enable cable select," or "Cable select". If necessary
refer to the documentation for the hard drive.
6. Using a No. 2 Phillips screwdriver, install the four screws that secure the new
hard drive to the tray.
7. Turn the hard drive tray upright.
8. Align the hard drive tray with the runners on the chassis, then push the tray in
until it stops and latches.
Note – If the tray does not slide easily, gently move the cables so the tray can slide.
9. Reconnect the primary hard drive power cable and the primary hard drive data
cable to the primary hard drive (
Note – The cables are keyed. Ensure that all the connector keys are properly
aligned.
10. Pushing against the metal edges, slide the hard drive tray in until the ejection
lever latches (
FIGURE 4-11
11. Connect the secondary hard drive data cable to the secondary hard drive and to
connector J503 on the riser board (
FIGURE 4-11 B).
A).
FIGURE 4-12
Chapter 4 Installing Optional Workstation Hardware
FIGURE 4-11
).
).
D
51