Figure 4-10 Installing A Cd-Rom Or Dvd-Rom Drive - Sun Microsystems Sun Blade 150 Getting Started Manual

2. Position the drive into the drive opening on the front of the workstation and push
the drive in until the screw holes on the drive line up with the screw holes on the
chassis (
3. Using a No. 2 Phillips screwdriver, install two screws that secure the drive to the
chassis.
CD-ROM or
DVD-ROM
drive
FIGURE 4-10
4. Connect the primary IDE 1 and power cables to the rear of the drive (
The following block diagram shows the cabling path between the riser board, the
CD-ROM/DVD-ROM drive, and the primary hard drive. Use this diagram to help
you route the primary IDE 1 channel cable.
Riser board
(connector J504)
5. Continue with "Finishing Component Installation" on page 53.
).
FIGURE 4-10
Power cable
Screw holes on drive
Installing a CD-ROM or DVD-ROM Drive
CD-ROM/ DVD-ROM drive
Connector J504
Drive opening
Primary hard drive
Chapter 4 Installing Optional Workstation Hardware
Primary IDE 1 cable
Screw holes in chassis
No. 2 Phillips
screwdriver
FIGURE 4-10
).
49