Finishing Component Installation - Sun Microsystems Sun Blade 150 Getting Started Manual

Finishing Component Installation

1. Remove your antistatic wrist strap from the chassis.
2. Reconnect the power cord to the workstation and to a grounded AC outlet.
Caution – There is a risk of equipment damage. When you reinstall the workstation
cover, ensure that you do not damage the data and power cables for the hard drives,
CD-ROM or DVD-ROM drives.
3. Reinstall the workstation cover.
Align the cover tabs with the slots on the workstation chassis, then slide the cover
toward the front of the workstation until the front cover tabs lock.
4. Replace the two screws that secure the cover to the workstation chassis.
5. If necessary, reconnect the following cables:
Network TPE connector
Mouse USB cable
Keyboard USB cable
Peripheral drives
Peripheral signal (data) cables
Peripheral power cables
Monitor signal (data) cable
Monitor power cable
Cables from any other external device
6. Power on the workstation, see "Powering On the Workstation" on page 10.
Chapter 4 Installing Optional Workstation Hardware 53