Tips For Using Icanview222; Alarm-In And Alarm-Out - iCanTek iCanView 222 User Manual

iCanView222 User's Guide

6. Tips for using iCanView222

6.1. ALARM-IN and ALARM-OUT

ALARM connectors are used to connect various sensing and alerting devices. Examples of sensing
devices are infrared sensors, motion sensors, heat/smoke sensors, magnetic sensor, etc. ALARM-
OUT is used for connecting alerting device such as loud speaker, flashing light, etc.
Relay Out
1. ALARM-IN
Connect the two wires of the sensors to "SNS IN". The sensor type can be set in
Administrative mode(Ref. 5.7).
CVBS GND
Figure 6-1. Terminal block for I/O connection
Output lines providing on-off switching are connected
CVBS Out
Sens In - Sens In +
Rev.1.0 (Mar. 2008)
50