Trouble Shooting - iCanTek iCanView 222 User Manual

iCanView222 User's Guide
-
+
Relay
You can use the supported relay output to directly drive a maximum load of
30V AC/DC at 1A. By connecting additionally relay circuitry (such as optional relay
switch), it can also drive heavier loads.

6.2. Trouble Shooting

1. After iCanView222 is successfully installed.
• iCanView222 in viewing mode, neither channel name nor video is display and
eventually timeout message is shown up.
Check the power and network connection of iCanView222.
To check if the network is properly operating, open the browser and try to connect to any
server.
Example) http://www.yahoo.com
Or open the MS-DOS Prompt and type the following.
ping www.yahoo.com
Then press Enter. If you see the "
working properly. To check if the iCanView222 is connected, open the MS-DOS Prompt and
type the following.
ping [the IP of the server]
Example) ping 192.168.1.112
If you see the
Relay Switch Power Supply
1V~30VDC/AC,1A
Relay1
Relay1
Reply from
"Reply from ..." message, it means that the server is properly connected.
Optional
Relay Switch
..." message it means that the network is
Rev.1.0 (Mar. 2008)
Alarm
Out
Device
Power
Supply(30V
~)
Alarm
Out
Device
Power
Supply
(1~30 1~30
) )
VDC/AC,1A VDC/AC,1A
53