Web Viewer - iCanTek iCanView 222 User Manual

iCanView222 User's Guide
If you do not see a Reply message, check if the network cable and power cable are
properly connected.
2. After Successfully Connecting to the iCanView222
• Video movement is slow.
In Basic Setup of Admin Mode, lower the "Quality". High quality means more data. You can also
set the "Max. upload rate" to higher value. But this value must be lower than the maximum
upload speed of your network. For example, if the maximum uploading bandwidth of the
network is 400Kbps, set the total "Max. upload rate" as 384Kbps. If you set it higher, the video
image can be corrupted with artifacts.
Ask your network manager or ISP for maximum uploading bandwidth of the network.
• The image is dull and I see green, pink dots.
This could be caused by performance limitation of the PC. Do not run too many programs while
running viewer program. The other reason could be missing data while transmission from
iCanView222.
• Mosaic phenomenon.
Mosaic phenomenon occurs when not enough network bandwidth is available considering the
resolution and frame rate of the video.
Example is 704x480 video with low Max. upload rate.
Users are recommended to adjust resolution and frame rates to lower values for lower
bandwidth network.

6.3. Web Viewer

iCanView222 is designed to be connected through internet explorer, too. For connection to
iCanView222 using internet explorer type in IP address or host address in the address input field of
the internet explorer.
Rev.1.0 (Mar. 2008)
54