iCanTek iCanView 222 User Manual page 15

iCanView222 User's Guide
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
xDSL or Cable modem you need supplementary information provided by your ISP.
4. Connect to iCanView222 in Administrator Mode for initial parameter set-up.
All parameters are set to factory default state when iCanView222 is delivered. You are
asked to configure the system for your environment in administration mode. Detailed
information of using administration mode can be found in
in Administrative
should be set-up with proper values. Detailed information for the parameters in
Administrator Mode is found in
[Note]: Set-up values are preserved even the power is turned off.
Page Parameter
Video Size
Max Upload Rate
Basic Setup
Frame Rate
Video Rate
User Admin Administrator
& Time name &
Setup password
User Admin
& Time Current Time
Setup
5. Connect the input and output signals to iCanView222.
[IP-Installer User's
Mode]. Among the parameters, the parameters in the following table
[5. Configuring iCanView222 in Administrative Mode]
Setup value
Set the resolution
transmitted from iCanView222.
Set this value smaller than the upload
speed of your network.
The number of
transmitted per second.
Bandwidth assigned
transmitted from iCanView222.
For safety, you are recommended to
change these values from factory
default. For new connection, you need
to input changed
corresponding fields. Do not disclose
these values to others and memorize
these values.
Input correct time in this field.
Guide]. If network type is
[5. Configuring iCanView222
Factory default value
of the video
Make sure that you press Check
button to find out the number of
maximum possible simultaneous
u sers then set the number of
frames to be
users smaller than or equal to the
nu mber.
for video
values for
Rev.1.0 (Mar. 2008)
Default value
Username : root
Password : dw2001
Default value :
2001/1/1
15