Tips For Using Icanview110; Alarm-In And Alarm-Out - iCanTek iCanView 110 User Manual

iCanView110/110W User's Guide

6. Tips for Using iCanView110

6.1. ALARM-IN and ALARM-OUT

ALARM connectors are used to connect various sensing and alerting devices. Examples of sensing
devices are infrared sensors, motion sensors, heat/smoke sensors, magnetic sensor, etc. ALARM-
OUT t is used for connecting alerting device such as loud speaker, flashing light, etc.
Figure 6-1. ALARM-IN/ALARM-OUT Connector
1. ALARM-IN
Connect the two wires of the sensors. The sensor type can be set in Administrative
Mode(Ref. 5.5 & 5.6). Output lines providing on-off switching are connected between
"+" and "-" pins. Figure 6-2 shows the input circuit of "Alarm In".
Rev.1.4 (Jan. 2005)
48 of 56