iCanTek iCanView 222 User Manual page 29

iCanView222 User's Guide
Sub Field
Field/Button
/Button
Static IP Set
IP Assign Type PPPoE Setup
DHCP Setup
Clone MAC
RTSP
Port Change
HTTP
Restrict
Administrator
Access
IP Filtering Base IP
Address
Mask
E-Mail Setup
The network
LAN(fixed IP), PPPoE, and DHCP(automatic IP allocation)
When the network environment is fixed IP, select 'LAN' in the
network type, and put the IP address, Subnet Mask, Gateway,
up DNS1 and DNS2. Ask your network administrator or ISP for the
information. DNS2 is used when DNS1 does not work.
When the network environment is PPPoE and IP address is
assigned automatically, select 'PPPoE' in the network type.
Next, fill in the 'User Name' and 'Password' fields with the
values assigned by the ISP.
When the network environment is "automatic IP allocation by
DHCP", select 'DHCP' in the network type. For cable modem
connection, select this mode.
Refer to [IP-installer user's guide]
domain for Cable Modem
Refer to [IP-installer user's guide]
Each port should have a number below 65535.
The RTSP port is used for transmitting real time audio/video
data from the network camera. Default is 554.
HTTP port is used for the connection to the admin page.
Default is 80.
You can restrict the access to the administrator page from IP
addresses beyond certain IP address range.
Check at this box to restrict administrative log on.
Input IP address of the PC which is intended to be used for log
on to administrative mode.
This is same as subnet mask. It is used to allow administrative
log on only to the PCs located in the same subnet as the base
IP address. If you want to allow only one PC to access in
administrative mode, set this value to 255.255.255.255.
Description
types supported by
Rev.1.0 (Mar. 2008)
the iCanView222 are
for "Host name and
for "Clone MAC"
29