iCanTek iCanView 222 User Manual page 48

iCanView222 User's Guide
System S/W
Upgrade
Manual
Upgrade
Bootloader
Upgrade
Add PTZ File
Factory
Default
Setting
System Reset
Note that automatic upgrade is not supported for
standard product.
Upgrade the system manually.
Upgrade the system software installed in the network camera
via the network. System software needed for the upgrade can
be downloaded from iCanTek's home page.
Refer to [6.4. How To Upgrade Your iCanView222
System].
Upgrade the bootloader installed in the network camera via the
network. Bootloader
downloaded from iCanTek's home page.
Refer to [6.4. How To Upgrade Your iCanView222
System].
Add a new PT driver software via the network. PT driver can be
downloaded from iCanTek's home page.
Refer to [6.4. How To Upgrade Your iCanView222
System].
Re-initialize the network camera to factory default state.
By checking on a Radio button "Except Network Configuration",
you can preserve the parameters for the network. Checking on
"All", will return all the parameters to factory default state.
Once iCanView222 is re-initialized as factory default
state, it should be set-up again using IP-Installer.
Perform remote reset by clicking the "CONFIRM" button.
All previous connections will be disconnected upon
reset. iCanView222 does not resume the connections
and the users must re-connect to the server manually.
needed for the upgrade
Rev.1.0 (Mar. 2008)
can be
48