iCanTek iCanView 222 User Manual page 25

iCanView222 User's Guide
Audio Input
Selection
Input Video
Video Size
Max upload
Frame rate
Video Quality
Video rate
& Bandwidth
Control Audio rate
Check
Possible Max
Users
Remained
Limited users
Save
Select the type of input audio.
Select Line In for using Line-out from audio devices.
Select Mic for using microphone.
This filed is set by the factory
Select a video size for transmission-
NTSC(30 frames/sec Max.) : 176x144 / 352x240 /
720x480.
PAL/SECAM
352x288 / 720x576
Assign maximum bandwidth of the uplink for the network
rate connected to iCanView222.
Assign number of video frames to be transmitted for each
second. You can improve picture quality by lowering frame
rate for the same bandwidth.
Assign bandwidth for transmitting video data.
Assign bandwidth for transmitting audio data. Audio data is
not transmitted if you select "NA"
After you finish set up of video and audio for all the channels,
click on this box to obtain the
users (Possible
bandwidth
users are connected.
It shows the number of maximum simultaneous connections
for the network connection set-up.
It shows the network bandwidth remaining when
Users are connected.
Useful network bandwidth varies according to the condition of
the network. This parameter is used to limit the number of the
simultaneous connections below the number shown in
Max Users.
Save the set-up parameters when the set-up parameters are
done.
(25 frames/sec
possible maximum number of
Max Users)
(Remained) remaining when possible maximum
Rev.1.0 (Mar. 2008)
Max.) : 176x144
and remaining network
Possible Max
Possible
/
25