Tips For Using Icanview240/250; Alarm (For Sensor Input) And Aux(For Relay Output) - iCanTek iCanView 240 User Manual

iCanView240/250 User's Guide

6. Tips for Using iCanView240/250

6.1. Alarm (for Sensor input) and AUX(for Relay output)

Alarm terminal at the connector panel of iCanView240/250 is used to connect various sensing and alerting
devices. Examples of sensing devices are infrared sensors, motion sensors, heat/smoke sensors, magnetic
sensor, etc. Aux terminal is used for connecting alerting device such as loud speaker, flashing light, etc.
1. "ALARM" connector for Sensor Input to iCanView240/250
Connect the two wires of the sensors. The sensor type can be set in i-NVR.
1) Please run i-NVR , connect iCanView240 or 250 and click on the "Virtual System Controller"
button and then you will get Virtual System Controller screen
2) Select the "menu" button on Virtual System Controller, then OSD menus are displayed on the
corresponding video display screen of the iNVR. Using the buttons on the "Virtual System Controller"
select "ALARM", "ALARM NO." and then "ALARM INPUT" sequentially. The screen changes are
illustrated in Fig.6-1
Fig.6-1 Setup the Sensor Type at iNVR/Virtual System Controller
Rev.1.0 (Dec.2006) 50