Kipor IG2000 Shop Manual page 19

Measure the spark plug gap and
perform the spark plug test.
Standard clearance: 0.6—0.7mm
No spark
Perform the spark test again using a
new spark plug
No spark
Remove the control panel. Perform
the spark test using a new igniter.
No spark
Check the engine switch
No spark
Disconnect the low oil alarm and
perform spark test
No spark
Check the resistance of motor
ignition winding
Normal
Check the trigger
Normal
Check the ignition coil resistance
and high pressure cable, high
pressure insulation cap.
Normal
Inspection or replace wire harness.
Good spark
Replace the spark plug
Good spark
Good spark
Replace the engine switch
Good spark
Replace the low oil alarm
Abnormal
Replace the motor stator
Abnormal
Replace the trigger or readjust
Abnormal
Replace the ignition coil
18
Replace the igniter
trigger clearance