Proxim ORiNOCO AP-4000M User Manual page 213

Command Line Interface (CLI)
Configuring the AP using CLI commands
Value Corresponding Antenna Enabled
1 802.11b/g (connector 1)
2 802.11b/g (connector 2)
3 802.11a/4.9 GHz (connector 3)
4 802.11a/4.9 GHz (connector 4)
5 (auto) Both antennas on interface
NOTE: See Antennas
Set the Distance Between APs
[Device-Name]>set wif <index> distaps <1–5> (see below)
[Device-Name]>reboot 0
Value Distance Between APs
1 Large
2 Medium
3 Small
4 Mini
5 Micro
Set Ethernet Speed and Transmission Mode
[Device-Name]>set etherspeed <value> (see below)
[Device-Name]>reboot 0
Ethernet Speed and
Transmission Mode
10 Mbits/sec - half duplex
10 Mbits/sec - full duplex
10 Mbits/sec - auto duplex
100 Mbits/sec - half duplex
100 Mbits/sec - full duplex
Auto Speed - half duplex
Auto Speed - auto duplex
Set VLAN parameters
[Device-Name]> set ethvlanmode <value 0-3>
This command is configured to select any of the four modes. The values represent the four VLAN modes. They are as
follows:
0-Transparent Mode
1-Trunk Mode
2-Access Mode and
3-Mixed Mode.
for more information on internal and external antenna ports.
Value
10halfduplex
10fullduplex
10autoduplex
100halfduplex
100fullduplex
autohalfduplex
autoautoduplex (default)
AP-4000/4000M/4900M User Guide
213