Proxim ORiNOCO AP-4000M User Manual page 214

Command Line Interface (CLI)
Configuring the AP using CLI commands
[Device-Name]>ethvlanaccessid <value 1-4094>
This command stands for the Access VLAN ID configuration. The values range from 1 to 4094.
[Device-Name]>set ethvlanpriority <value 0-7>
For Access VLAN Priority, there are eight values. The default is 0 and the maximum is 7.
[Device-Name]>set ethvlanid01-16 <value -1-4094>
For the VLAN 1 to 16, the values range from -1 to 4094. The value -1 represents the untagged frames.
Set Interface Management Services
Edit Management IP Access Table
[Device-Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>
Configure Management Ports
[Device-Name]>set snmpifbitmask <(see below)>
[Device-Name]>set httpifbitmask <(see below)>
[Device-Name]>set telifbitmask <(see below)>
Choose from the following values:
Interface Bitmask
0 or 2 = Disable (all interfaces) All management channels disabled
1 or 3 = Ethernet only
4 or 6 = Wireless A only
8 or 10 = Wireless B only
12 = Wireless A and Wireless B Wireless A and Wireless B enabled
13 or 15 = Enable all interfaces All management channels enabled
Set Communication Ports
[Device-Name]>set httpport <HTTP port number (default is 80)>
[Device-Name]>set telport <Telnet port number (default is 23)>
Configure Secure Socket Layer (HTTPS)
Enabling SSL and configuring a passphrase allows encrypted Secure Socket Layer communications to the AP through
the HTTPS interface.
[Device-Name]>set sslstatus <enable/disable>
The user must change the SSL passphrase when uploading a new certificate/private key pair, which will have a
corresponding passphrase.
[Device-Name]>set sslpassphrase <SSL certificate passphrase>
[Device-Name]>show http (to view all HTTP configuration information including SSL.)
Description
Ethernet only enabled
Wireless A only enabled
Wireless B only enabled
AP-4000/4000M/4900M User Guide
214