Advanced Configuration
Interfaces
Mesh
Mesh functionality can be enabled on only one of the AP's wireless interfaces. When configured for Mesh, the AP's
wireless interface simultaneously functions as a Mesh link and as a radio to service clients.
CAUTION: Mesh mis-configuration may cause problems in your wireless network. Before configuring an interface for
Mesh functionality, see
NOTE: AP-4000 units must use software version 3.4 (or later) to enable mesh functionality. For information on upgrading
your unit's software, see
Basic Mesh Parameters
Figure 4-23 Basic Mesh Parameters
Configure the following basic parameters for Mesh functionality, and click OK.
NOTE: Changes to these parameters require a reboot in order to take effect.
•
Mesh Mode: Use this drop down menu to enable/disable Mesh functionality on a wireless interface. When Mesh
Mode is set to Disable, all other parameters on this tab will be grayed out. To enable Mesh functionality, choose one of
the following:
–
Mesh Portal: Choose this option if the AP will be connected directly to the wired backbone.
–
Mesh AP: Choose this option if the AP will connect to the portal and backbone wirelessly.
NOTE: Proxim recommends enabling Auto Channel Select when configuring an AP as a Mesh AP. Auto Channel
Select is configured on the Wireless A or Wireless B page. See
Wireless-B (802.11b/g Radio)
•
Mesh Radio: Select the wireless interface on which to enable Mesh functionality. Select Wireless Interlace A
(802.11a/4.9 GHz radio) or Wireless Interface B (802.11b/g radio).
•
Mesh SSID: Enter a unique Mesh Network Name (SSID) between 1 and 16 characters.
NOTE: Do not use quotation marks (single or double) in the Network Name; this will cause the AP to misinterpret the
name.
Mesh Network
Configuration.
Installing the
Software.
for more information.
AP-4000/4000M/4900M User Guide
Wireless-A (802.11a/4.9 GHz Radio) and
78