Proxim ORiNOCO AP-4000M User Manual page 206

Command Line Interface (CLI)
Configuring the AP using CLI commands
[Device-Name]>set snmprpasswd <New Password> (SNMP read password)
[Device-Name]>set snmprwpasswd <New Password> (SNMP read/write)
[Device-Name]>set snmpv3authpasswd <New Password> (SNMPv3 authentication password)
[Device-Name]>set snmpv3privpasswd <New Password> (SNMPv3 privacy password)
[Device-Name]>reboot 0
CAUTION: Proxim strongly urges you to change the default passwords to restrict access to your network devices to
authorized personnel. If you lose or forget your password settings, you can always perform the
Factory Defaults.
Set Network Names for the Wireless Interface
[Device-Name]>set wif <3 (Wireless Interface A) or 4 (Wireless Interface B)> netname
<Network Name (SSID) for wireless interface>
[Device-Name]>show wif
Figure A-13 Results of "show wif" CLI command for an AP
Enable 802.11d Support and Set the Country Code
NOTE: On APs with model numbers ending in -WD, these commands are not available.
Perform the following command to enable 802.11d IEEE 802.11d support for additional regulatory domains.
[Device-Name]>set wif <3 (Wireless Interface A) or 4 (Wireless Interface B)> dot11dstatus
<enable/disable>
Perform the following command to set a country code:
[Device-Name]>set syscountrycode <country code>
Select a country code from the following table, derived from ISO 3166. Available countries will vary based on regulatory
domain. Refer to the ISO/IEC 3166-1 CountryCode drop-down menu on the Configure > Interfaces > Operational
Mode page; this menu contains a list of all the available countries in your regulatory domain.
NOTE: If you select a country code that is not supported in your regulatory domain, clients may attempt to connect to a
channel that is not supported by your AP.
Country
Algeria
Albania
Code Country
DZ Honduras
AL Hong Kong
AP-4000/4000M/4900M User Guide
Code Country
HN Panama
HK Papua New Guinea
Soft Reset to
Code
PA
PG
206