Command Line Interface (CLI)
Configuring the AP using CLI commands
MAC Address Format
Response Time
Maximum Retransmission
Authorization Lifetime
Accounting Update Interval
Accounting Inactivity Timer
Index
Primary/Backup
Profile Name
Server Status
Server Addressing Format
IP Address/Host Name
Destination Port
VLAN Identifier
MAC Address Format
Response Time
Maximum Retransmission
.
.
.
Index
Primary/Backup
Profile Name
Server Status
Server Addressing Format
IP Address/Host Name
Destination Port
VLAN Identifier
MAC Address Format
Response Time
Maximum Retransmission
Authorization Lifetime
Accounting Update Interval
Accounting Inactivity Timer
Figure A-16 Result of "showradiustbl" CLI Command
Set Rogue Scan Parameters
Perform the following command to enable or disable Rogue Scan on a wireless interface and configure the scanning
parameters.
The cycletime parameter is only configured for background scanning mode.
[Device-Name]>set rscantbl <3 or 4> mode <1 for background scanning, 2 for continuous
scanning> cycletime <cycletime from 1–1440 minutes> status <enable/disable>
NOTE: Rogue Scan cannot be enabled on a wireless interface when the Wireless Service Status on that interface is
shutdown. First, resume service on the wireless interface.
: dashdelimited
: 3
: 3
: 0
: 0
: 5
: 1
: Backup
: MAC Authentication
: notReady
: ipaddr
: 0.0.0.0
: 1812
: -1
: dashdelimited
: 3
: 3
: 4
: Backup
: Management Access
: notReady
: ipaddr
: 0.0.0.0
: 1812
: -1
: dashdelimited
: 3
: 3
: 0
: 0
: 5
AP-4000/4000M/4900M User Guide
217