Proxim ORiNOCO AP-4000M User Manual page 246

Command Line Interface (CLI)
Parameter Tables
Syslog Parameters
The following parameters configure the Syslog settings.
Name
Syslog
Syslog Status
Syslog Port
Syslog Lowest Priority
Logged
Heartbeat Status
Heartbeat Interval
(seconds)
NOTE: When Heartbeat is enabled, the AP periodically sends a message to the Syslog server to indicate that it is active.
The frequency with which the heartbeat message is sent depends upon the setting of the Heartbeat Interval.
Syslog Host Table
The table described below configures the Syslog hosts that will receive message from the AP. You can configure up to
ten Syslog hosts.
Name
Syslog Host Table
Table Index
IP Address
Comment (optional)
Status (optional)
Type
Group N/A
Integer enable
disable (default)
Octet String 514
Integer 1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG
Integer enable (1)
disable (2) (default)
Integer 1 - 604800 seconds;
900 sec. (default)
Type
Table N/A
Integer 1 - 10
IpAddress User Defined
DisplayString User Defined
Integer enable
disable
delete
AP-4000/4000M/4900M User Guide
Value Access
R
RW
R
RW
RW
RW
Value Access
R
N/A
RW
RW
RW
CLI Parameter
syslog
syslogstatus
syslogport
syslogpritolog
sysloghbstatus
sysloghbinterval
CLI Parameter
sysloghosttbl
index
ipaddr
cmt
status
246