Command Line Interface (CLI)
Parameter Tables
Name
Medium Occupancy
Factor
Signal Strength Cutoff
Max Hops to Portal
Mesh Mobility Mode
(Mesh AP only)
Reset Mesh Parameters
‡
to Defaults
Mesh QoS Profile
Mesh Link Only (no client
access on Mesh radio)
Mesh Auto Switch Mode
(Mesh Portal only)
Current Mesh Mode
* Higher roaming threshold value creates a more static Mesh environment. Lower roaming threshold value creates a more dynamic Mesh
environment.
† A QoS profile corresponding to this index number must exist.
‡ This command resets the following parameters to their default values: Maximum Active Mesh Links, Maximum Hops to Portal, Hop Factor,
RSSI Factor, Medium Occupancy Factor, Receive Signal Strength Cut-off, and Roaming Threshold.
* The value 1 for oriWirelessIfSSIDTablePXUProfile refers to not more than one PXU Profile is allowed to choose from.
Type
Integer32
0–10
Integer32
0–26
Integer32
1–4
Integer
1 (static)
2 (roaming)
Integer32
1 or 2
Integer32
1–10
Integer
1 (enable)
2 (disable)
Integer
1 (enable)
2 (disable)
Integer
1 (Disabled) (default)
2 (Mesh Portal)
3 (Mesh AP)
Value
Access
†
AP-4000/4000M/4900M User Guide
CLI Parameter
RW
meshmedocfactor
RW
meshsignalstrengthcutoff
RW
meshmaxhops
RW
meshmobility
RW
meshadvresettodefault
RW
meshqosprofile
RW
meshlinkonly
RW
meshautoswitchmode
R
meshcurrentmode
238