Usage And Maintains Of Print Head; Usage Of Xaar Printer - GRAPHTEC SignJet JS310 Series User Manuals

V.1

Usage of Xaar Printer

1. Flush humectants out of Print head
To moisturize Print head, lots of humectants are injected into the head before it is used. The
humectants must be flushed out for the first using. Before fix the head on the Print head frame, do the
steps as follows: Joint a filter on the Inlet-tube of the head, and then joint an injector--which fills with
flush solution--on the filter. Inject 10-20 ml flush solution to the head to eject the humectants inside.
Then fill the head with flush solution to dissolve the humectants completely within 5-10 minutes.
Finally, flush the head with about 30ml flush solution to eliminate the humectants completely. Make
sure to operate on a stable and clean platform.
Cautions:
1. Clean platform for convenient operation;
2. Don't touch the surface of head and socket with hand;
3. Clean the filter with flush solution;
4. Connect a tube on the exit of the head to prevent ink flowing into the socket;
5. Don't touch the surface of head with other objects;
6. Be careful to distinguish Inlet tube and Outlet tube of the head;
7. Eject flush solution from the nozzles with strength no more than 0.3 kg. (It is better to hold the
injector with single hand and push it with the same thumb.)
SignJet JS310 Series User's Manuals
4
5
3
1.－ Print head
2.－ Inlet tube
3.－ Outlet tube
4.－ Outlet tube cap
5.－ Fitting
Figure 5-1 Print head
V

Usage and Maintains of Print head

- 19 -
2
1