Example - CipherLab 1660 User Manual

1660 Barcode Scanner

EXAMPLE

Without using the scanner to read the above setup labels for configuring the 3610 dongle,
you may run HyperTerminal.exe on the host computer to send serial commands to 3610
via USB Virtual COM or HID.
1) Connect 3610 to the USB port of PC.
2) The Communication LED will indicate when 3610 can accept serial commands after
initializing. Refer to the table below.
Communication LED
--- Blue,
solid
Red, Blue,
solid flashing
Red, Blue,
flashing flashing
If the output interface is USB Virtual COM, run HyperTerminal.exe on your
computer. While the Communication LED on 3610 is purple (red with flashing
blue), type the serial command within 3 seconds.
If the output interface is USB HID, press the "NumLock" or "CapsLoack" key via
the keyboard 5 times within 3 seconds while the Communication LED on 3610 is
flashing red and blue. This will change the interface from USB HID to USB Virtual
COM and the Communication LED will become purple (red with flashing blue).
Then, run HyperTerminal.exe on your computer. While the Communication LED on
3610 is purple (red with flashing blue), type the serial command within 3 seconds.
After configuring via serial commands, the interface will be reset to USB HID after
re-connecting 3610.
168
User Guide
Meaning
Initialize
Serial command mode with USB Virtual COM: wait 3 seconds for
starting a serial command
Serial command mode with USB HID: wait 3 seconds for pressing
[NumLock] or [CapsLock] 5 times via keyboard
Enter Setup