Getting Familiarized With 1660 And 3610; Installing Batteries To 1660 - CipherLab 1660 User Manual

1660 Barcode Scanner

GETTING FAMILIARIZED WITH 1660 AND 3610

INSTALLING BATTERIES TO 1660

1) Hold the scanner face down in one hand.
2) Press the battery lid release and slide the battery lid.
3) Remove the battery lid by the other hand.
4) Install two AAA Alkaline batteries into the battery compartment, each in the right
direction.
5) Replace the battery lid and lock it firmly.
6) Hold down the [Power/Delete] key for about 2 seconds to turn on 1660.
The scanner will respond with a long beep (high tone) and its LED indicator will
become solid red and go off quickly.
Note: To turn off the scanner, press the [Power/Delete] key for 2 seconds. The scanner
will respond with two short beeps (high tone) and the LED will finally become solid
red. Release the key then. Otherwise, let the scanner turn off automatically in
specific circumstances. Refer to settings of
For shipping and storage purposes, save the scanner and the batteries separately.
This will keep the batteries in good condition for future use.
2
User Guide
"Auto Power Off".
Enter Setup