Auto Power Off Mode; Aiming Mode - CipherLab 1660 User Manual

1.6.5 AUTO POWER OFF MODE

The scanner will start scanning once the trigger is pressed.
The scanning won't stop until the pre-set timeout expires, and, the pre-set timeout
period re-counts after each successful decoding.
Note: Refer to "Delay between Re-read" and "Scanning Timeout".

1.6.6 AIMING MODE

The scanner will aim at a barcode once the trigger is pressed, and start scanning when
the trigger is pressed again within one second.
The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Aiming Timeout
You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.
1. Read the label above to specify the time interval before aiming ends. (It is set to 1 by default.)
2. Read the "Decimal
automatically shut down after being idle for 10 seconds.
3. Read the "Validate" label on the same page to complete this setting.
Auto Power Off Mode
Aiming Time-Out after 1~15 seconds (*1)
Value" label on page 171. For example, read "1" and "0" for the scanner to
Chapter 1 Understanding the Barcode Scanner
Aiming Mode
Update
31