Continuous Mode - CipherLab 1660 User Manual

1.6.1 CONTINUOUS MODE

The scanner is always scanning.
After a successful decoding, the removal of barcode is required. It is not allowed to
proceed to decode until the decoding delay time has passed.
To decode the same barcode repeatedly, move away the barcode and put it back
again and again for scanning.
Note: Refer to "Delay between Re-read".
Decoding Delay
Set the time interval between each decoding.
*Disable
1 sec
Chapter 1
Continuous Mode
Understanding the Barcode Scanner
Update
0.5 sec
2 sec
29