CipherLab 1660 User Manual page 29

high. If the scanner fails to resume connection, it will try every 5 seconds to re-connect to the
host unless you have the scanner read the "Reset Connection" label.
For BT SPP, the scanner must wait for the host to re-connect.
With the use of 3610, the scanner will try re-connecting to 3610 unless you turn off the
scanner.
1) Read the label above to specify the time interval before the scanner automatically
turns off.
2) Read the "Decimal
scanner to automatically turn off after being idle for 15 minutes.
3) Read the "Validate" label on the same page to complete this setting.
Note: Auto Power Off will not take effect when the scanner is in the configuration mode.
1) Read the label above to specify the time interval before the scanner automatically
turns off.
2) Read the "Decimal
scanner to automatically turn off after being idle for 15 minutes.
3) Read the "Validate" label on the same page to complete this setting.
Note: Power-Saving will not take effect when one of the following conditions is met:
(1) the scanner has already established a BT HID/SPP connection,
(2) the scanner is in the configuration mode,
(3) the scan mode is set to Test, Continuous or Alternate Mode, or
(4) the setting value of Power-Saving is greater than that of Auto Power Off.
Auto Off after 0~254 minutes (*10)
Value" label on page 171. For example, read "1" and "5" for the
Power-Saving after 0~254 minutes (*2)
Value" label on page 171. For example, read "1" and "5" for the
Chapter 1 Understanding the Barcode Scanner
Update
17