Selecting Output Interface - CipherLab 1660 User Manual

SELECTING OUTPUT INTERFACE

In order to establish a proper connection between your computer and the scanner, we
suggest that you follow these instructions -
1) Install batteries and hold down the [Power/Delete] key for about 2 seconds to turn on
the scanner.
2) Have the scanner read the "Enter Setup" label to enter the configuration mode.
3) Have the scanner read the associated label to activate the desired interface.
See the following sections for output interfaces supported.
4) Have the scanner read the labels for related settings.
5) Have the scanner read the "Update" label to exit the configuration mode.
6) Turn on your computer or laptop and establish a WPAN connection with the scanner.
Refer to Chapter 3 - Setting up a WPAN
Note: By default, the output interface is set to "BT HID".
IN THIS CHAPTER
2 .1 BT HID ..................................................................... 42
3
2 .2 BT SPP ..................................................................... 49
3
2.3 USB HID via 3610 ...................................................... 51
2 .4 USB Virtual COM via 3610 ........................................... 58
3
Connection.
Update
Chapter 2
41