Auto-Transmit 1, Enable; Auto-Transmit 2, Enable - Intermec 3440 User Manual

HelvC

Auto-Transmit 1, Enable

Purpose: Enables auto-transmit level 1.
Syntax:
<ESC>j
The status response codes are as follows:
<DC1>
<FS>
<BS>
<EM>
<US>
<US>
Notes: The printer automatically transmits the status response codes listed above
when necessary. This command becomes effective upon execution.

Auto-Transmit 2, Enable

Enables auto-transmit level 2.
Purpose:
Syntax:
<ESC>d
Notes: At level 2, the printer automatically transmits the status response code
<DC1> (room in input buffer). Without auto-transmit enabled, the host
must use the <ENQ> or <VT> command to determine the status. This
command becomes effective upon execution.
C o d e 3 9
N
ugFont
Fault cleared
Label at strip pin
Takeup reel full
No label stock
Ribbon fault
Label path open
Configuration Commands
*1233*
FG 9pt Italic
6
6-39