Intermec 3440 User Manual page 144

3440 Bar Code Label Printer User's Manual
Use the <ETX> and <STX> characters to mark the beginnings and ends of
the command strings. The following table explains the other characters.
Most of the printer command lines explained below are those that contain
commands previously not discussed in this chapter. Refer to previous
examples for clarification of the lines that this example does not explain or
see Chapter 6, "IPL Commands," for a further explanation of the command
language.
Command Description
<ESC>C1
Selects 2.5 mil Advanced mode.
<ESC>P
Selects Program mode.
E1;F1;
Erases anything previously stored as format one and accesses the location for
format one.
H0; Defines field 0 as a human-readable field.
f3; Rotates field 0 by 270 degrees counterclockwise around the origin.
o980,180; Sets the origin of field 0 at coordinates 980,180.
c26; Sets the font for field 0 to font 26.
d3,Diamond Sets the data for field 0 to have the constant value: Diamond Corp.
Corp.;
h28;
Sets the height of font 26 to 28 dots.
w20;
Sets the width of font 26 to 20 dots.
U1; Defines graphic field 1.
o950,40; Sets the origin for field 1 at 950,40.
c2; Selects graphic 2 to print in graphic field 1.
h6; Sets the height of field 1 to 6 dots.
w6; Sets the width of field 1 to 6 dots.
f3; Rotates field 1 by 270 degrees counterclockwise around the origin.
5-42
*1233*
FranklinGothic