Using Test And Service Mode Procedures - Intermec 3440 User Manual

1233*
This chapter explains the different procedures you can perform while the 3440
printer is in Test and Service mode. Use Test and Service mode on the 3440
printer to print test labels, perform special procedures such as cloning, and
change select configuration commands.

Using Test and Service Mode Procedures

For all Test and Service tests, pressing the Feed/Pause button pauses the
current test. Holding the Feed/Pause button aborts the current test and
starts a new test.
To enter Test and Service mode
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while turning the power on.
3. Set the DIP switches to the test or service function you wish to perform.
4. Hold the Feed/Pause button down. The test begins immediately.
5. If you wand to perform another function, change the DIP switch settings
To exit Test and Service mode
1. Turn the printer power off.
2. Reset the DIP switches to their original settings.
3. Turn the printer power back on.
The printer remains in Test and Service mode until you turn the power off
again and reset the DIP switches. The printer executes all functions as soon
as you select them. Use the information in the following table to set the DIP
switches for the appropriate Test and Service mode function you want to
perform.
FranklinGothic Helv Cond
The printer prints out a hardware configuration label and then enters
Data Line Print mode.
See the following table for a list of the DIP switch settings.
and press the Feed/Pause button.
The function the printer is currently executing terminates, and the
printer performs the new function.
Using Test and Service Mode
8
8-3