Intermec 3440 User Manual page 205

C o d e 3 9
N
HelvC ugFont
,m2
Recommended Data Amount
0 *
1 *
2 1 - 40
3 41 - 160
4 161 - 320
5 321 - 863
6 †
7 †
8 †
9 ‡
* You should only use ,m2 values of 0 and 1 if your labels do not have enough space
for more error correction characters. These values are generally not recommended.
† The printer reserves ,m2 values of 6, 7, and 8 for special applications where the
symbol is subject to damage and requires a higher level of error correction.
‡ An ,m2 value of 9 lets the printer set m2 to the recommended value for each
symbol based on the number of characters. An m2 value of 9 is the default setting.
Using ,m3 to Set the Truncate Flag
,m3 is a truncate flag that indicates whether to print the symbol in truncated
form. If truncated, the symbols print without right row indicators and with
only a one-module wide stop character. The values for ,m3 are 0 to disable
truncating and 1 to enable truncating. The default is 0. To minimize errors
and maintain the best reading performance, Intermec recommends that you
leave ,m3 equal to 0.
The following information shows the approximate data capacity (maximum
number of characters allowed) for the three character sets.
Character Set Data Capacity
Full ASCII 1108
Alphanumeric 1850
Numeric 2725
Note: 2D symbols encode data by compressing it in different amounts. Therefore,
use these values as guidelines. The exact data capacity varies with the actual data
being encoded.
Program Mode Commands
*1233*
FG 9pt Italic
Error Detection Characters
2 (error detected, no recovery)
4
8
16
32
64
128
256
512
6
6-59