Factory Default Settings - Intermec 3440 User Manual

3440 Bar Code Label Printer User's Manual

Factory Default Settings

The following table lists the factory default settings for the 3440 printer. Use
the downloadable printer commands described in Chapter 6, "IPL
Commands," to set these parameters. The printer's serial port defaults,
which are set using the rear panel DIP switches, are described in Chapter 2,
"Operating the Printer."
Configuration
Preamble Character
Postamble Character
Auto-Transmit 1
Auto-Transmit 2
Auto-Transmit 3
Message Delay
Power-Up Mode
Cutter
End-of-Print Skip Distance
Top of Form
Media Sensitivity
Number of Image Bands
Maximum Label Length
Printer Character Set
Label Retract
Label Retract Distance
Print Speed
Label Stock Type
Intercharacter Delay
Storage Memory
Label Taken Sensor
A-6
1233*
FranklinGothic Helv Cond
Default Setting
Disabled
Disabled
Disabled
Disabled
Disabled
0 milliseconds
2.5 mil Advanced mode
Disabled
123 - 5 mil increments on continuous stock
0 - 5 mil increments on label stock
20 - 5 mil increments
420 Direct Thermal/567 Thermal Transfer
3
1000 dots (5 inches)
US ASCII
Disabled
0
3 inches per second (ips)
Die-cut
0 milliseconds
256K
Disabled
FG 9pt Italic
FG 8pt Italic