Intermec 3440 User Manual page 52

3440 Bar Code Label Printer User's Manual
8. Release the lower media guide and adjust the edge guide (by unscrewing
9. If you are using thermal transfer media, you need to load ribbon. Follow
10. Lower the printhead by rotating the head lift lever counterclockwise
11. If you are loading continuous media or mark label stock, use your third-
12. Press Feed/Pause to advance several inches of media through the printer
Note: Refer to the label located on the inside of the media cover for directions on
loading media. For your convenience, you may want to refer to it when loading
media in the future.
Example of Selecting Continuous Label Stock Using DOS
1. At the DOS prompt, type the following command and press Enter:
2. Type the following command lines and press Enter:
3. Turn the printer power on and then off for the command to take effect.
2-8
1233*
it and sliding it) to position the media firmly against the inside wall of
the printer.
the instructions for "Loading Thermal Transfer Ribbon" later in this
chapter before you finish performing this procedure.
until it locks.
party software or the printer command set to tell the printer what kind
of media you are using.
An example of using the printer command set and DOS to configure
your printer follows this procedure.
and out the label opening in the front cover. Your printer is now ready to
print labels.
MODE COM1 96,E,7,1,N
This command configures the serial port.
COPY CON COM1
<STX><SI>T0<ETX>^Z
where:
COPY CON COM1 copies the information to COM1.
<SI>T0 sets the label stock type to continuous media.
^Z (Ctrl-Z) Enter sends the command to the printer.
FranklinGothic Helv Condensed
FG 8pt Italic