Installing Another Language - Ricoh B230 Service Manual

5. Enter the SP mode.
6. Do SP5-846-052 (Restore All Addr Book).
7. Exit the SP mode, and then turn off the main power switch.
8. Remove the SD card form the SD card slot 3.
9. Install the slot cover 3.
The counter in the user code information is initialized after uploading.
The information of an administrator and supervisor cannot be downloaded nor
uploaded.
If there is no data of address book information in the SD card, an error message is
displayed.

5.6.8 INSTALLING ANOTHER LANGUAGE

Many languages are available. But you can only switch between two languages at a time.
Do the following procedure to select the two languages you want. You can select both of
the languages you want from the user interface on the operation panel.
1. Switch the copier main power switch off.
2. Insert the SD card with the language data into SD Card Slot 3.
3. Switch the copier main power switch on. The initial screen opens after about 45
seconds.
4. Touch "Language Data (2)" on the screen (or press
5. Touch "LANG. 1(1)" or "LANG. 2(2)"
Key
SM
).
What it does
5-411 B230/B237