Ricoh B230 Service Manual page 1048

NCU Parameters
Address
Time between final OHDI relay
68054D closure and DO relay opening or
closing
Minimum pause between dialed
68054E
digits (pulse dial mode)
Time waited when a pause is
68054F
entered at the operation panel
680550 DTMF tone on time
680551 DTMF tone off time
Tone attenuation level of DTMF
680552
signals while dialing
Tone attenuation value difference
between high frequency tone and
680553
low frequency tone in DTMF
signals
PSTN: DTMF tone attenuation level
680554
after dialling
ISDN: DTMF tone attenuation level
680555
after dialling
680556 Not used
Time between 68054Dh (NCU
680557 parameter 14) and 68054Eh (NCU
parameter 15)
680558 Not used
Grounding time (ground start
680559
mode)
68055A Break time (flash start mode)
B786
Function
98
Unit
See Notes 3, 6 and 8.
SP2-103-015
1 ms (parameter 14).
This parameter is only
valid in Europe.
See Note 3 and 8. SP2-
103-016 (parameter 15).
20 ms
SP2-103-017
(parameter 16). See
Note 3.
SP2-103-018
(parameter 17).
1 ms
SP2-103-019
(parameter 18).
SP2-103-020
-N x 0.5 –
(parameter 19).
3.5 dBm
See Note 5.
SP2-103-021
(parameter 20).
The setting must be less
-dBm x 0.5 than –5dBm, and should
not exceed the setting at
680552h above.
See Note 5.
SP2-103-022
-N x 0.5 –
(parameter 21). See
3.5 dBm
Note 5.
-dBm x 0.5 See Note 5
Do not change the
-
settings.
This parameter takes
1 ms effect when the country
code is set to France.
Do not change the
-
setting.
The Gs relay is closed
20 ms
for this interval.
The OHDI relay is open
1 ms
for this interval.
Remarks
SM