Downloading Stamp Data; Nvram Data Upload/Download - Ricoh B230 Service Manual

Hide thumbs Also See for B230:

Table of Contents

5.6.5 DOWNLOADING STAMP DATA

The stamp data should be downloaded from the controller firmware to the hard disks at the

following times:

After the hard disks have been replaced.

The print data contains the controller software. Execute SP 5853 to download the fixed

stamp data required by the hard disks.

Enter the SP mode.

Select SP5853 and then press "EXECUTE". The following screen opens while

the stamp data is downloading.

The download is finished when the message prompts you to close.

Press the "Exit" button. Then turn the copier off and on again.

Uploading Content of NVRAM to an SD card

Do the following procedure to upload SP code settings from NVRAM to an SD card.

This data should always be uploaded to an SD card before the NVRAM is

Make sure that the write protection of an SD card is unlocked

Do SP5990-001 (SMC Print) before you switch the machine off. You will need a

record of the NVRAM settings if the upload fails.

Switch the copier main power switch off.

Insert the SD card into SD card slot 3. Then switch the copier on.

Table of Contents