New Debug Log Codes - Ricoh B230 Service Manual

2. On the control panel, enter "01". Then hold down
the machine beeps and then release it. This saves the debug log to the hard disk
for later retrieval with an SD card by the service representatives.
3. Switch the machine off and on to resume operation.
The debug information for the error is saved on the hard disk. This lets the service
representative retrieve it on their next visit by copying it from the HDD to an SD card.

5.9.4 NEW DEBUG LOG CODES

SP5857-015 Copy SD Card-to-SD Card: Any Desired Key
This SP copies the log on an SD card (the file that contains the information written directly
from shared memory) to a log specified by key number. The copy operation is executed in
the log directory of the SD card inserted in the same slot. (This function does not copy from
one slot to another.) Each SD card can hold up to 4 MB of file data. Unique file names are
created for the data during the copy operation to prevent overwriting files of the same name.
This means that log data from more than one machine can be copied onto the same SC
card. This command does not execute if there is no log on the HDD for the name of the
specified key.
SP5857-016 Create a File on HDD to Store a Log
This SP creates a 32 MB file to store a log on the HDD. However, this is not a completely
empty file. The created file will hold the number "2225" as the SCS key number and other
non-volatile information. Even if this SP is not executed, a file is created on the HDD when
the first log is stored on the HDD (it takes some time to complete this operation). This
creates the possibility that the machine may be switched off and on before the log can be
created completely. If you execute this SP to create the log file beforehand, this will greatly
reduce the amount of time required to acquire the log information and save onto the HDD.
With the file already created on the HDD for the log file, the data only needs to be recorded.
A new log file does not need to be created. To create a new log file, do SP5857-011 to
delete the debug log data from the HDD. Then do SP5857-016.
SP5857-017 Create a File on SD Card to Store a Log
This SP creates a 4 MB file to store a log on an SD card. However, this is not a completely
empty file. The created file will hold the number "2225" as the SCS key number and other
non-volatile information. Even if this SP is not executed, a file is created on the SD card
when the first log is stored on the SD card (it takes some time to complete this operation).
This creates the possibility that the machine may be switched off and on before the log can
be created completely. If you execute this SP to create the log file beforehand, this will
greatly reduce the amount of time required to acquire the log information and save onto the
SM
for at least 3 seconds until
5-427 B230/B237