Approved Vent
Rear Vent Configuration
Manuafacturer
Simpson Dura-Vent
Metal-Fab Inc.
Top Vent Configuration
Manuafacturer
Simpson Dura-Vent
Metal-Fab Inc.
* Top vent configurations using Simpson GS vent may use 6-5/8" diameter Simpson GS vent. If
using 6-5/8" diameter vent, attach the 8" to 6-5/8" reducer (Travis part # 98900165) to the fireplace
(see the illustration below).
Vent Installation
•
Slide the vent sections together and turn 1/4 turn until the sections lock
in place.
•
Screws are not required to secure the vent. However, three screws may
be used to secure vent sections together if desired.
•
High temperature sealant is recommended at the appliance starter
section connection (use high-temperature silicone or Mill-Pac®).
•
If disassembly is required, at time of re-assembly check to see if the vent
creates a tight fit. If it does not, apply high temperature sealant to the
joints of the affected sections.
•
Horizontal sections require a 1/4" rise every 12" of travel
•
Horizontal sections require non-combustible support every three feet (e.g.: plumbing tape)
© Travis Industries
Installation
(for qualified installers only)
Ext. Dia.
8 "
8 "
Ext. Dia.
8" or 6-5/8" *
8 "
Series
Model GS
Direct-Vent with 5DHT or 5DVT Cap
Series
Model GS*
Direct-Vent with 5DHT or 5DVT Cap
6-5/8" Diameter Vent
Reducer - # 98900165
4050714
21
100-01173