Travis Industries 864TRV Installation Manual page 64

64 Optional Equipment
Floor Mounting
Cut a hole between floor joists
a
for the blower box.
5-1/4"
Slide the blower into the hole
c
cut in step "a". Attach with four
screws.
Attach the starter ring to the fireplace following the directions below (use the most convenient side
- 864TRV has only one opening on the right side).
Travis Industries
b
14"
1/4" Nutdriver
4050714
(for qualified installers only)
Attach the floor boot to the blower box with the included screws.
Starter Ring
Remove and discard the
cover plate.
Bend the tabs on the bottom of
the starter ring up to lock it in
place.
The screws
attach to either
of these pairs of
holes. Use the
upper pair for
thick flooring, the
lower pair for
thin flooring.
100-01173_001