Travis Industries 864TRV Installation Manual page 59

Hide thumbs Also See for 864TRV:

Table of Contents

Optional Equipment

4. Attach the wiring and rheostat assembly following the directions below.

NOTE: You may need to cut or adjust some of the lock ties on the wiring harness.

NOTE: Make sure wiring does not contact blower impellers or any hot surfaces. Use lock-ties if

necessary.

Attach one black and

white wire to each

blower (orientation does

not matter).

Attach the wires labeled

SNAP DISC to the

snap disc (orientation

does not matter).

5. Turn on power to the fireplace.

NOTE: To test the blower without turning on the fireplace, use a jumper wire to connect the two

snap wires together (turn off power prior to connecting the jumper wire).

(for qualified installers only)

Plug the power cord into the

receptacle at the rear of the fireplace.

Attach the rheostat assembly to the

fireplace with the two black screws.

4050714

These wires are for the optional

remote control. Place them behind

the gas control valve.

100-01173_001

Table of Contents