Travis Industries 864TRV Installation Manual page 54

54 Finalizing the Installation
5 Replace the rear burner. Set the rear burner air shutter to a 3/16" gap.
Loosen the screw on the air
shutter and rotate the air shutter.
6 Replace the firebox
components. Install the
logs and embers.
Replace the glass.
7 Remove the regulator
from the front of the gas
control valve. Replace
with the propane
regulator, using the new
gasket and screws
included with the
regulator. NOTE: Leak
test this area after the
heater is installed, gas
is connected, and the
main burner is lit.
Travis Industries
Rear Burner Air Shutter
This gap is the air shutter opening.
a
Remove and discard the three
screws using a slotted screwdriver
of Torx T-20.
Slotted
Screwdriver
(or T-20 Torx)
c
Install the LP regulator. Use
the screws included with the
LP regulator. Tighten to
approximately 25 Lbs. torque.
Slotted
Screwdriver
(or T-20 Torx)
(for qualified installers only)
4050714
For LP Units:
Start with the rear air shutter
set to a 3/16" opening.
b
Remove and discard the
regulator, diaphram, spring
and center post.
NOTE: Make sure the
regulator gasket is correctly
aligned before installation.
d
Place the LP
label on the base
of the fireplace
near the gas
control valve.
100-01173_001