Variables For Hl-660 - Brother HL-Series Technical Reference Manual

Revision C 16/01/96

Variables for HL-660

1) General PJL Environment Variables
The PJL environment variables which are not printer language-specific are listed in the following table.
When using these valuables, do not use the LPARM.
Variables
COPIES
MANUALFEED
ECONOMODE
ECONOLEVEL
PERSONALITY
XOFFSET
YOFFSET
AUTOCONT
TIMEOUTEMU
PRIORITY
AUTOFF
TIMEOUTFF
TIMEOUT
CDCCHIGH
DTRCTRL
AUTOSLEEP
TIMEOUTSLEEP
IBMCHARE1
REPRINT
DEMOPRINT
PAGEPROTECT
RESOLUTION
LANG
KEEP PCL
DOUBLESTRIKE
Description
Number of uncollated copies for each page of
the job.
Feed the paper from manual feed slot or not.
Turn the economy mode (toner saving mode)
ON or OFF.
Select the toner saving level from 1 (high) to
3 (low).
Set the emulation mode.
Set the X offset ( horizontal offset ) value.
Set the Y offset ( vertical offset ) value.
Auto Continue Mode
Set the time-out value for automatic
emulation switching.
Set the priority between EPSON or IBM for
automatic emulation switching.
Set the auto FF setting to ON or OFF.
Set the timeout value for auto FF.
Set the time-out value for Automatic interface
switching
Set the high-speed transfer mode of
Centronics interface to ON or OFF.
Select when DTR becomes low.
0 = the printer is turned off-line by SEL
switch, input buffer is full, or printer error
occurs.
1 = the printer is turned off-line by SEL switch
or printer error occurs.
2 = the printer is turned off-line by SEL
switch.
Set the automatic sleep mode ON or OFF.
Set the timeout value for automatic sleep
mode.
Set the reprint function ON or OFF.
Enable the Demo page printing or not.
Configuration of the Page protection mode.
This mode reserves a block of printer memory
to avoid 31 PRINT OVERUN error.
Printer resolution setting. If the printer can
not print a large file at 600 dpi because of
insufficient memory, the printer decreases the
resolution to 300 dpi automatically
Select the language for RPC program.
If set to ON, the printer keeps the permanent
font and permanent macro of PCL when the
emulation is changed to the other mode.
Enable the bold printing in IBM or EPSON
mode
Chapter 3 "PJL" - 22
Sample Value Range
1 to 200
ON or OFF
ON or OFF
1 to 3
AUTO, PCL, IBM,
EPSON, POSTSCRIPT
-500 to 500 dots
-500 to 500 dots
ON or OFF
1 to 99 seconds
EPSON or IBM
ON or OFF
1 to 99 seconds
1 to 99 seconds
ON or OFF
0 to 2
ON or OFF
1 to 00 minutes.
BETA or ESSZET
ON or OFF
ON or OFF
AUTO, OFF, LETTER,
LEGAL, A4
300, 600
ENGLISH, FRENCH,
GERMAN, DUTCH or
NORWEGIAN
ON or OFF
ON or OFF